Page 3
3BE390843NU – 01/12
BONNET GRANDE CUISINE
Registered office:
Rue des Frères Lumière - Z.I Mitry Compans
77292 MITRY MORY Cedex
the European Union, or in another State so far the transfer of these residues out of France is
made according to the provisions of the Regulation of 1st February 1993 indicated above.
- he must make sure that all fluids of electric and electronic equipment are drained according to
the requirements of the provisions.
- he must make sure that the information relating to the removal and treatment of these residues
is forwarded to any further acquirer.
♦
The warranty will not cover problems caused by failure to comply with these recommendations.
Table top and free standing induction specification:
♦
To avoid scratching the glass top of your unit do not slide pans across the surface.
♦
If a crack appears in the vitroceramic top disconnect the electrical supply immediately.
♦
Never put aluminium foil or plastic material onto the hot surface.
♦
Repairs must only be undertaken by personnel authorised and approved by the manufacturer.
♦
Never use aluminium foil it will melt and burn and almost certainly damage your unit.
♦
Metal cooking utensils, lids, knives and other metal objects should not be left close to a pan that is being
heated.
♦
Be careful about items carried by people using the hob, things such as rings, bracelets and watches could
get hot if too close to the hob.
♦
Metallic objects such as lids, cutlery etc should not be left on the hob as they may get heated if in the
cooking area.
♦
Do not stack things on the cooking surface no matter what.
♦
Only use cookware of the recommended types and sizes.
♦
Whilst in use do not put anything on the surface that is or could be magnetised or that could be damaged
by a strong magnetic field (credit cards, cassettes, usb sticks…).
♦
In the event of spillages or splashes onto the unit (glass surface and controls) the electronics are fully
protected and are not at risk of damage.
♦
People with pacemakers or other active implants should note that induction creates a magnetic field in
close proximity to the cooking surface but complies with current norms for electromagnetic disturbance.
However for there to be no interference with your implant it too must conform with these regulations.
If there is any doubt you should consult the manufacturer or your medical practitioner.
♦
Note: Because the air inlet is under the unit table top induction units should not be located on a
closed base and the technical cupboard under a free standing induction unit should not be used
for storage.
Table top units should only be installed on:
- one piece leg assembly with 4 adjustable feet and an undershelf.
- mobile leg frame with 4 castors, 2 braked and an undershelf.
♦
Attention, the unit should not be installed near any form of heat source such as : solid tops, open
burners, fryers, grills, bain maries etc….
