Bonnet B-CAP.IN5 Installation Instructions Manual Download

Page: 7 / 7

Page 6

390 526NI – 11/05

BONNET CIDELCEM GRANDE CUISINE
Siége social:
Rue des Frères Lumière - Z.I Mitry Compans
77292 MITRY MORY Cedex

3. INSTALLATION: CONNECTIONS

3.1 ELECTRICAL CONNECTION

The appliance is equipped with a 1.5 m long supply cable for connecting with a 3-pole + earth (not

supplied) connector which complies with the EN 60.083 standard.

Provide a suitable isolating device (with contact separation of at least 3mm) in accordance with current

regulations.

The installation must comply with current applicable national legislation (for France, standard NF

15.100).

The appliance must be connected to the earth.

The manufacturer cannot be held responsible if these instructions are not followed.

Summary of Contents for B-CAP.IN5

Page 1: ...ersonnel approved by the manufacturer and in accordance with current regulations and standards If any modifications are made the manufacturer can accept no responsibility whatsoever These appliances must be used in a well ventilated area Read the notice carefully before installation The unit must be kept on its base for handling until it is in its final location N 390526NI 9 ...

Page 2: ...ns 77292 MITRY MORY Cedex CONTENTS 5 KW INDUCTION WOK A TECHNICAL DATA 2 B FITTER S INSTRUCTIONS 1 Location of the identification plate 4 2 Installation General features 5 2 1 General requirements 5 2 2 Handling 5 2 3 Unpacking 5 2 4 Installation 5 3 Installation Connections 6 3 1 Electrical connections 6 ...

Page 5: ...2 MITRY MORY Cedex 1 IDENTIFICATION PLATE The identification plate is fixed under the equipment about the back part see the diagrams below In any correspondence about your equipment please quote The model number Model The serial number Fab Nr The date Date Identification plate Location of the identification plate ...