Instructions n°648261 –
Page 8
3. OPERATION
3.1 GENERAL REQUIREMENTS
Ensure that the fans are not obstructed.
If the appliance has been laid down during transport or handling, wait 24 hours before
use to allow refrigerant oil to return to the compressor.
3.2 PRESENTATION OF THE CONTROL PANEL
3.3 ELECTRONIC CARD SETTING
3.3.1 CONFIGURATION OF PARAMETERS
The appliance is delivered from the factory with a standard configuration to fit the most
current uses (see paragraph 1.3, page 4 of the user manual). If needed, this configuration
can be modified.
There are 2 levels of configuration :
Level 1 : Accessible to user (see ‘User manual’ page 9, paragraph 1.6)
Level 2 : Password protected, only accessible to installer to select and change the
factory setting of all parameters (see ‘Table of parameters’ paragraph
3.3.2 of page 9)
Parameters accessible at level 1 are also accessible at level 2.
The parameters’ modifications, at level 1 as well as at level 2, are definitively taken into
account, even after the stop of the appliance.
When the appliance is used for the first time, it is necessary to program a code which
must be set with the user, and which must be attributed to the chiller with the L5 and L6
parameters. Check the date and the hour of the regulator’s internal clock with the i4, i5, i6, i7,
and i8 parameters.
On/off switch
Led
key
Led
Sound alarm
off key
Cycle end
(preservation)
Led
- Temperature
- Duration (
h.mn
)
- Coded defect
Display
Up setting
Start cycle
or validation
Down setting
Led
Running
cycle
Defrost cycle
and/or
prefunction cycle
Cycle
with timer
key
Core probe
cycle
Fragile
products
Led
key
Led
key
Programming keys
Leds
Defect
Led
key
Led
key
Chilling
cycle
Freezing
cycle
