3B-390977NU – 10/18
Page 7
EN
BONNET GRANDE CUISINE
Rue des Frères Lumière - Z.I Mitry Compans
77292 MITRY MORY Cedex
- Unlock the ventilation duct and swing it open by pulling it towards you for 10 GN 2/1 and 20 level ovens. For other models leave the
duct in place
- Spray detergent on all the exposed surfaces. Only use products specifically designed for cleaning professional stainless steel
cooking cavities.
- Close the duct and lock it shut (10 GN 2/1 and 20 level ovens)
- Spray the cooking cavity and refit the runners or module
- Spray the runners or module and the inside or the door, then close the door.
The cleaning cycle will start automatically and last 17 minutes.
The display indicates time remaining.
- At the end of the cycle the display indicates « End ». The time display indicates « 00 00 » and the buzzer sounds ( 5 times).
14.2 AUTOMATIC CLEANING STARTED MANUALLY
Pressing the Cleaning/Tools button gives access to the cleaning menu
Display shows “CLEA” (cleaning) in the timer zone and the intensity in the temperature
zone. By default the last cycle used is displayed.
Possible selections:
- 3 cleaning intensities
- Rinse function
- Cleaning product priming function
Intensity
Time
6/10 lev
20 lev
1
17 min
26 min
2
26 min
36 min
3
36 min
37 min
Rin
2 min
2 min
Pri
2 min
2 min
The priming function allows the detergent delivery circuit to be refilled when the
container is changed so that efficiency is maintained
A parameter in the CHEF menu allows you to program a daily automatic start time and
the desired wash intensity
Pressing the “Start button” starts a wash cycle.
Pressing the Cleaning/Tools button or any
inactive zone exits this menu and returns to the
previous screen.
Procedure:
- Press the button:
"Cleaning mode"
- Select the required level of cleaning depending on how dirty the oven is.
Select cleaning intensity of 1 to 3
- Check the pipe is connected to the chemical container and that the quantity is sufficient. If not refer to the paragraph “Replacing the
chemical containers”
- Then press the “Start” button:
"Start" a cleaning cycle.
- It is still possible to change the intensity of the cleaning cycle whilst the zone is flashing (phase before detergent is injected). Whilst
the timer is still displayed:
Time remaining before the end of the cycle.
- At the end of the cycle the display indicates "00 00".
