Page 1
3BE390691NM – 10/10
BONNET GRANDE CUISINE
Registered Office:
Rue des Frères Lumière - Z.I Mitry Compans
77292 MITRY MORY Cedex
TABLE OF CONTENTS
COMBI OVENS
SI
1.
FUNCTIONING AND MARKING OF THE MAXI RELAY CARD.............................................................. 2
2.
PARAMETER SETTING OF THE UC RELAY CARD.............................................................................. 3
2.1
GENERALITIES ....................................................................................................................................................3
2.2
PARAMETER SETTING OF THE CONFIGURATION KEY .................................................................................3
2.3
PARAMETER SETTING OF THE FACIA (in case the whole card is changed) ...................................................5
2.4
OUTLET FROM THE PARAMETER CYCLES .....................................................................................................6
3.
OPERATIONAL FAILURES .................................................................................................................... 7
4.
CHANGING THE EQUIPMENT FROM ONE GAS TO ANOTHER .......................................................... 8
4.1
LIST OF AUTHORISED GASES/PRESSURE ACCORDING TO CATEGORIES AND COUNTRIES..........................................8
4.2
CHANGEOVER FROM ONE GAS TO ANOTHER:..............................................................................................9
4.3
GAS FLOW RATES AND POWERS ..................................................................................................................11
4.4
CHART OF NOZZLES ........................................................................................................................................11
5.
MAINTENANCE .................................................................................................................................... 14
5.1
SERVICING THE CONDENSER ........................................................................................................................14
6.
VERIFICATION OF TEMPERATURE SENSORS.................................................................................. 15
7.
DOOR ADJUSTMENT AND CLOSING ................................................................................................. 17
7.1
6 & 10 LEVEL OVENS........................................................................................................................................17
7.2
20 LEVEL OVENS ..............................................................................................................................................18
8.
RENEWAL OF THE DRIVING SHAFT GASKET................................................................................... 20
9.
FRONT LINE PARTS ............................................................................................................................ 22
10.
MAINTENANCE PROGRAMME ........................................................................................................ 23
10.1
INLET INTO THE PROGRAMME .......................................................................................................................23
10.2
COUNTER READING .........................................................................................................................................23
10.3
ASSISTANCE FOR MAINTENANCE .................................................................................................................24
10.4
OUTLET FROM MAINTENANCE CYCLES .......................................................................................................25
