Page 8
BONNET CIDELCEM GRANDE CUISINE
Siége social:
Rue des Frères Lumière - Z.I Mitry Compans
77292 MITRY MORY Cedex
2.4 REMOVAL
OF THE FACIA
- Unscrew and remove the 2 M5 x
16 screws under the fascia.
- Remove front to do so, lift front 1),
then pull the bottom edge
outwards and downwards (2).
Attention
: Do not let the facia hang by the ribbon cables connecting to the generator, disconnect them at the
generator.
- For re-assembly, reverse the above operations. A label stuck on one of the facia card covers indicates how
to reconnect the cables.
2.5 ASSEMBLY ONTO A SINGLE UNDERFRAME
Place appliance on the underframe, with the rear of the
appliance and the underframe approximately aligned.
(The underframe is symmetric, front and rear are
identical).
Push the unit backwards until the hooks in the base
locate into the 25mm square holes provided
Repeat these two operations for each appliance to be
fitted on the same underframe.
