IMPORTANT RECOMMENDATIONS
∗
The installation should be entrusted to approved contractors and
comply with all current regulations.
∗
Before locating the unit ensure that the air circulation and volume
are sufficient to allow normal cooling of the condenser and
compressor.
∗
Avoid installing the cabinet near major sources of heat or in direct
sunlight.
∗
Note that too high an ambient operating temperature can reduce
performance
∗
When connecting electrically earth continuity must be maintained
between the unit and the supply socket.
∗
The supply cable that is fitted is a specific part and should only be
replaced with an original part. Ensure that the plug is easily accessible
as a means of electrical isolation.
∗
Protection against electrical overload or faults is the responsibility of
the installer. Ensure that a circuit breaker or fuses are fitted in the
supply circuit (See data plate).
∗
All operations on the electrical or refrigeration circuits, including
cleaning should only be undertaken with the unit DISCONNECTED
(unplugged)
∗
The air cooled compressor condenser must be cleaned regularly
(Every 3 to 6 months).
∗
The unit should not be sprayed or splashed with water:
. Do not use a jet wash on the exterior or technical parts of the
unit.
. The equipment must not be installed in the fresh air or exposed
to the elements.
∗
Correct functioning depends on the factory fitted safety systems being
respected. No responsibility can be accepted for malfunctions that
result from modifications undertaken on our equipment.
∗
The manufacturer can not be held responsible so the equipment be
used for anything other than the purpose it was designed for.
ALL SPECIFICATIONS AND CHARACTERISTICS IN THIS
MANUAL MAY BE SUBJECT TO CHANGE WITHOUT NOTICE
