Returning the packaging to the materials cycle conserves raw materials and reduces
the amount of waste that is generated. Dispose of packaging materials that are no
longer needed in accordance with applicable local regulations.
NOTE:
If possible, keep the original packaging during the warranty period so that the device
can be properly packed for returning in the event of a warranty claim.
Scope of Delivery
The appliance is supplied withthe following components as standard:
1 x Vacuum Sealer
1 x Roll Vacuum
5 x Vacuum Bags (15x25cm)
Film
5 x Vacuum Bags (20x30cm)
2 x EVA Seal Ring
Check the package for completeness and for signs of visible damage.
If the consignment is incomplete or damaged due to defective packaging or carriage,
please contact us.
Installation Requirements
For safe and trouble-free operation of the device, the set
-
up location must ful
fi
ll the
following requirements
:
When setting it up, place the appliance on a
fi
rm,
fl
at and horizontal surface.
Do not place the device in a hot, wet or extremely damp environment or in the vicinity
of
fl
ammable materials.
The mains power socket must be easily accessible, so that the power cable can be
easily disconnected in the event of an emergency.
Electrical Connection
Before connecting the device, compare the connection data (voltage and frequency) on
the type plate with those of your power supply. This data must match to prevent
damage to the device.
Make sure that the power cord is undamaged and does not run over hot surfaces
and/or sharp edges.
Make sure that the power cord is not taut or bent.
Do not let the power cable hang over edges (trip wire effect).
Insert the plug into the mains power socket.
Sealing Vacuum Bags
The bag widthmay not exceed 30cm
.
Otherwise it cannot be welded correctly.
Use only nylon-PE
fi
lms with a structure
(
points or grooves) on oneside and athickness
of approximately 0.15 - 0.30 mm. Otherwise the weld seam will not be tight and the
appliance may be damaged. You can recognize bags of this type from the information
on the package. The quality of the weld seam will vary depending on the type and
thickness of the bag.
Cut the desired length for your bag from theroll. Open the device cover bypressing the
cover release and fold the cover upwards. Place the open end of the bag in the machine
so that the opening of the bag lies centrally under the lower sealing ring. The bag should
4
Summary of Contents for VS3905
Page 12: ......
