Warning!
1. No part of this tool shall be hammered or knocked. When
the working head, handle and other parts of the tool are
damaged, it will increase personal injury accidents.
2. When there is no mold in the working jaw, please do not
perform crimping operation, otherwise it will damage the
tool and may cause personal injury!
3. The tool body and the hand-held rubber sleeve do not
have electrical insulation. Do not use the wire or the
terminal with electricity to avoid personal injury!
4. When the tool is no longer in use, loosen the oil return
bolt counterclockwise. If it is left unused for a long time,
please check the crimping mold and related accessories in
time, loosen the oil return bolt counterclockwise to reset
the piston to the end, wipe the surface of the tool clean, and
apply anti-rust grease on the metal surface of the crimping
mold and tool.
5. During the process of extending the tool piston, do not
put your fingers or any part of your body into the jaws to
avoid being pinched!
6. Please select the crimping mold reasonably according to
the wire specifications and the corresponding copper /
aluminum terminals.
