Mounting Instructions:
Before Mounting:
Welcome to Blackboard
™
Write:
Clear:
Before first use:
1. Select approximate location for mounting Blackboard
and mark height on wall.
2. Use a level and draw a horizontal line the full width of
Blackboard on the wall (approximately 1307.8 mm / 51.5 in.)
3. Using a stud finder (not included), make a small mark
on the line to identify stud locations.
4. Choose two studs that are at least 32” apart to secure
the two included mounting brackets using the four
included screws. Drill four pilot holes using 3/32” drill bit.
Be sure to keep the two mounting brackets aligned and
level when securing to wall.
5. Carefully slide Blackboard onto the mounting brackets.
6. Using a pencil, make a mark on the wall through the
two bottom mounting holes.
7. Remove Blackboard from the wall. Using a ¼” drill bit,
drill a hole on the two corner marks and press the includ-
ed drywall anchors into the holes.
8. Mount and reposition Blackboard so that the wall
anchors are aligned with the two mounting holes.
9. Secure Blackboard directly to the wall using one screw
in each of its two bottom corners.
10. Carefully slide each corner cap into position over the
two bottom corners until you hear or feel a click.
Insert corner cover inserts into bottom two corner
covers. The corner cover insert should be pushed
flat against the corner cover.
Be sure to remove the plastic tab located on the battery
door before use.
Use the included inkless Blackboard™ Marker for an experi-
ence that feels familiar.
A simple press of the Clear Button clears the Blackboard’s
entire writing surface.
55”
(diagonal)
writing surface
wall hangers
clear button
corner cover
Blackboard™
Marker
magnetic ledge
mounting hole
(screw + anchor included)
mounting hole
(screw + anchor included)
battery door
4 (four) AA batteries
stud
stud
stud
Blackboard
™
55 Doane
™
Series
Package Includes:
Tools Needed:
(x1) Blackboard™ by Boogie Board® 55
(x1) Blackboard Marker
(x2) Bottom-Left/Top-Right Corner Covers
Wall Stud Finder
Level
Phillips No. 2 Screwdriver
(x2) Wall Hangers
(x6) Mounting Screws
(x2) Bottom-Right/Top-Left Corner Covers
(x2) Corner Cover Insert
(x2) Drywall Anchor
Drill with 1/4” Drill Bit
3/32” Drill Bit
Pencil
Tape Measure
