9
6 channels
Fonction
Contrôle de la fonction
CH1
Dimmer
0-255:Dimming 0%-100%
CH2
Strobe
0-255:Strobe from slow to fast
CH3
Red
CH4
Green
CH5
Blue
CH6
White
Attention: How to set master-slave without connecting to DMX
1. The Sound Master-slave :
Link all fixtures. Don’t connect the DMX Controller, set the
address to A001, choose one fixture as Master, and set the one to Sound model(so 1,so 2).
Then sound master-slave mode is achieved.
2,The Auto program Master-
slave : Link all fixtures. Don’t connect the DMX Controller,set
address to A001, choose one as Master, and set to Auto model(de 1,de 2...de 9). Then auto
master-slave mode is achieved.
-Set DMX address
Display the DMX 512 value of each channel. With this function you can display the DMX
512 value of each channel. The display automatically shows the channel with a value
changing.
Error message
When you turn on the fixture, it will make a reset first. The display may show XXer while
there are problems with one or more channels. XX stands for channel 1, 2, 3, etc who has
the testing sensor for positioning. For example, when the display shows Red Er , it means
there is some error in channel 1,If there are some errors on channel 1, channel 2, channel
5 at the same time, you may see the error message Red Color Er , Green Er ,Pan Er flash
repeated for 5 times, and then the fixture will generate a reset signal, all the stepper reset.
If the fixture remain error message after performing reset more than 3 times, it will detect
whether the fixture has more than 3 errors. If the fixture has more than 3 errors (including
3 errors), all the channels cannot work properly; but if the fixture has less than 3 errors,
only the channels which have errors cannot work properly, others can work as usual.