Page:
8
OIM - Manual
Version:
2014/11
Speedlane 900
Edition:
SL900 -OIM - USA
3
Technical description
3.1 General
The Speedlane 900 consists of two opposite units (basic unit), each of which has been equipped
with a mechanism operating the glass door wings. The door wings slide from a casing resulting in a
standard position with completely blocked access (normally closed). The access width with both
door wings fully opened is 20 inch or 510 mm. This width is narrow enough to prevent two persons
passing the Speedlane 900 while walking next to each other. The wide Speedlane 900 has an
opening of 35 ¾ inch or 910 mm for the access of wheelchairs and trolleys.
The unit is 39 3/8 inch or 1000 mm high (excluding the top plate). The total length of the standard
Speedlane 900 is 54 15/16 inch or 1395 mm; the length of the long Speedlane 900 is 101 9/16 inch
or 2580 mm. This length is required for proper (secure) interaction between the sensors and the
sliding door wings in the normally open mode.
The height of the glass door wings of the standard Speedlane 900 is 35 7/16 or 900 mm; the height
of the high Speedlane 900 is 47 ¼ or 1200, 55 1/8 or 1400, 63 or 1600, 70 7/8 inch or 1800 mm.
This height has been chosen to prevent people attempting to climb over the door wing.
The chosen width, and the opening and closing speed result in a capacity of 25 to 30 persons per
minute in one direction, depending on the authorization system chosen. In a fully open situation,
without authorization, the capacity can be increased to 120 persons per minute.
All described components are mounted in the Speedlane 900. The Speedlane 900 is driven by two
3-phase motors. The motor is connected to a control system, which consists of a control unit and a
frequency inverter.
Speedlane 900
NON-SECURED SIDE
SECURED SIDE
