198
Caution!
The cooking hob becomes very hot
during operation.
Keep children well out of reach.
N.B. When the cooker is not being
used, set the gas knobs to their closed
positions and also close the cock
valve on the gas bottle or the main gas
supply line.
Fig. 3.3
Fig. 3.4a
LIGHTING GAS BURNERS FITTED
WITH SAFETY VALVE DEVICE
(Dual burner)
In order to light the burner, you must:
1. Push and turn the knob in an clockwise
or anticlockwise direction up to the
position (maximum rate of inner
crown) or
position (maximum
rate of inner + outer crown), push in
and hold the knob until the flame has
been lit (fig. 3.4a or 3.4b).
The sparks produced by the lighter
situated inside the relative burner will
light the flame.
In the event that the local gas supply
conditions makes it difficult to light the
burner in
or
position, try
again with the knob in
position.
If there is no main electrical supply,
bring a lighted match close to the
burner.
2. Wait for about ten seconds after the
gas burner has been lit before letting
go the knob (safety device activation
delay).
3. Adjust the gas valve to the desired
position.
If the burner flame should go out for some
reason, the safety valve will automatically
stop the gas flow.
To re-light the burner, return the knob to
the closed
position,
wait for at least
1 minute
and then repeat the lighting
procedure.
Fig. 3.4b
Summary of Contents for CFBG903AN
