Borg Locks Help Line:
+44 (0) 1708 225700
BL3100 & 3400 ECP Series
Fitting XL Latchbolt - Part No.
BLGATELATCHNEW
To fit the XL latchbolt, the existing latchbolt will need to be removed. The tools required to fit are a 1.5mm (1/16”)
hex key and 4mm (3/16”) hex key.
Please Note: Before following step 1, it is advised that the 2 x grub screws are heated with
hot
water to
.
release the thread lock. Take
extreme
care when pouring
ho
t
water onto the grub screws.
1.
Using a 1.5mm (1/16”) hex key, remove the 2 x hex head grub screws located either side of
the latch sleeve
As per
Fig.1
and
Fig.2
below.
Fig.1
Fig.2
Fig.3
2.
Using a 4mm (3/16”) hex key, remove the hex head bolt located in the end of the latchbolt as per
Fig.3
. Keep this
bolt, as this will be needed when the XL latchbolt is fitted.
3.
Holding the latchbolt sleeve, grip and rotate the latchbolt anti-clockwise until it comes away from the sleeve - as
per
Fig.4
Fig.4
Latchbolt
Sleeve
Latchbolt
Fig.5
Latchbolt
Sleeve
XL Latchbolt
Ball
Bearing
4.
Ensure that the 2 x ball bearings are in line with the holes either side of the XL latchbolt as per
Fig.5.
If there is
not already - place a small amount of grease around the ball bearings to ensure they do fall out of the holes.
With
the bearings in position, screw the threaded part of the XL latchbolt (clockwise) into the latchbolt sleeve until both
halves join as per
Fig.6.
Continued Page 2
Ball Bearing &
Latchbolt Hole
Fig.6
