24
www.BormannTools.com
INFORMATION FOR USAGE
1. Safety valve and/or pressure limiting valve
Warning-danger!
Do not tamper with or adjust the safety valve setting.
The safety valve is also a pressure limiting valve.When the gun trigger is released,the valve
opens
,
p
ressure switch action, the machine automatically shut down.
。
If the gun nozzle is blocked, will cause the machine pressure rises, the safety valve opens,
the pressure switch action, the machine automatically shut down, you can refer to the
following point 7 to use a needle to clean the nozzle.
2. Automatic On/Off
The pressure cleaner is equipped with an automatic on/off switch. The pressure cleaner will
only run when the power switch is in the ON position and the trigger on the gun is squeezed.
When you release the trigger to stop spraying water through the gun, the motor on the
pressure cleaner will automatically shut off. Simply squeeze the trigger again to resume using
the cleaner. To stop using the pressure cleaner, release the trigger and switch the unit to the
OFF position. The unit should be turned completely OFF while not in use or while unattended.
3. Bleeding the Gun
It is very important to bleed the gun before using the pressure cleaner. Refer to the “Assembly
Instructions” to assemble the pressure cleaner. To bleed the gun, simply connect the garden
hose to the pressure cleaner and squeeze the trigger BEFORE turning the electrical supply
on. This allows any air trapped inside the pressure cleaner and gun to be removed before
using the unit. Continue holding trigger for approximately one minute to allow any excess air
out of the unit. Water will flow through the gun at low pressure during this procedure. For
more bleeding tips, see the section titled “Operating Instructions.”
4.Gun Safety Lock
This pressure cleaner is equipped with a gun trigger safety lock. When not using the pressure
cleaner, use the safety lock to keep from
accidentally engaging the high pressure spray.
Lock Unlock
