BorMann 036357, Manual

EN

WWW.BORMANNTOOLS.COM

6

Selecting the cutting action

This tool can be operated with an orbital or a straight line (up and down) cutting action. The orbital cutting action thrusts the jig saw blade forward on the cut-

ting stroke and greatly increases cutting speed. To change the cutting action, just turn the cutting action changing lever to the desired cutting action position. 

Refer to the table to select the appropriate cutting action.

1. Cutting action changing lever

Position

Cutting action

Applications

0

Straight line cutting 

action

- For cutting mild steel, stainless steel 

and plastics. 

- For clean cuts in wood and plywood.

1

Small orbit cutting 

action

For cutting mild steel, aluminum and 

hardwood.

2

Medium orbit cutting 

action

- For cutting wood and plywood. 

- For fast cutting in aluminum and mild 

steel. 

3

Large orbit cutting 

action

For fast cutting in wood and plywood.

Switch action 

CAUTION: Before installing the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position 

when released. 

To prevent the switch trigger from accidentally pulled, a lock-off button is pro-

vided. When the switch trigger is released, the tool will be automatically locked.

To start the tool, Press down the lock-off button, then simply pull the switch trig-

ger. Tool speed is increased by increasing pressure on the switch trigger. Release 

the switch trigger to stop.

Lighting up the front lamp

CAUTION: Do not look in the light or see the source of light directly.

When start the tool the LED lamp will light on in the same time. And the lamp 

goes out immediately after stopping the tool.

NOTE: Use a dry cloth to wipe the dirt off the lens of the lamp. Be careful not to 

scratch the lens of lamp, or it may lower the illumination.

1. Lock-off button 

2. Switch trigger

1

2

1. LED Lamp