8
please check
• whether there is voltage at the socket-outlet
• whether there is proper contact at the
charging contacts on the charger.
If the battery still fails to become charged, please
return
• the charger
• the battery pack
to our Customer Service Department.
To ensure that the battery pack provides long
service you should take care to recharge it
promptly.
You must recharge the battery pack when you
notice that the power Cordless Impact Driver
.
Never fully discharge the battery pack. This will
cause the battery pack to develop a defect.
ATTENTION
Please charge the battery pack regularly, for
example, once every 6 months.
Changing the Tool
Before any work on the power tool (e.g.,
maintenance, tool change, etc.) as well
as during transport and storage, set the
rotational direction switch to the center
position
. Unintentional actuation of the On/Off
switch can lead to injuries.
7.2 Install the socket (B5-B7)
- Push the socket(11) in tool holder(1).
- Slide the bolt (12) in the hole.
- Put the rubber sleeve on.
8. Starting Operation
8.1 Inserting the Battery
Use only original this brand Li-ion batteries
with the voltage listed on the nameplate of
your power tool.
Using other batteries can lead
to injuries and pose a fire hazard.
Set the rotational direction switch to the center
position to protect the power tool against
accidental starting. Insert the charged battery
into the handle so that it can be felt to engage
and faces flush against the handle.
8.2 Direction switch
You can toggle between right and left rotation by
pushing the direction of rotation
switch.
The direction changed may only be performed
in standstill mode!
8.3 Switching On and Off
To start the machine, press the On/Off switch
and keep it pressed. To switch off the machine,
release the On/Off switch.
8.4 Adjusting the Speed
The speed of the switched on power tool can
be variably adjusted, depending on how far the
On/Off switch is pressed. Light pressure on the
On/Off switch results in a low rotational speed.
Further pressure on the switch results in an
increase in speed.
8.5 Adjusting the power
This tool can work with different power by
adjusting the button(10).
8.6 Battery capacity indicator (B8)
The 3 color LEDs will indicate the status of battery
capacity as soon as you press the ON/OFF button.
All LEDs illuminate:
The battery is fully charged.
Two LEDs illuminate:
The battery has an adequate remaining charge.
One LED:
The battery is empty, recharge the battery.
8.7 LED lamp
The LED lamp (8) can be used in poor lighting
