5
www.BormannTools.com
REGULATING THE SPRAY GUN (Fig B – C)
Regulating the Spry Gun by turning the knob according to the Type of paint.
Proceed as
follows.
1.Turns knob counterclockwise.
2.Turn on the gun and spry.
3.Turn knob clockwise to obtain the correct atomization of the paint.
4.Turning the knob clockwise reduces the force of the sprays.
USAGE (Fig D - E - F)
To paint a surface without spotting, never turn the spray gun on or off while it is pointed at
the work surface. To avoid paint drips, do not apply excess paint one line. Figure F illustrates
the best method for obtaining optimum atomization. Spray uniformly and at a constant
distance (aproxx.12”). First on a horizontal surfaces, use the nozzle extension.
Fig D Right
Fig E Wrong
CARE AND CLEANING (Fig G-J)
Before and after use, thoroughtly clean the spry gun. Dye and paint residues may clog the
nozzle and moving parts, cau
sing the spray gun to become unusable. Once the spray gun has
been cleaned, and if it is not to be used again for a long period of time, it is advisable to
lubricate inner metal parts with small amount of oil.
IMPORTANT
If the spry gun is not thoroughtl
y cleaned after use, it may break upon reusage. Breakage as
a result of improper care or use is not covered in the warranty. Dried dye or paint residues
may be cleaned by soaking the damage parts in solvent and then cleaning them. Damage of
that cannot be
amended by cleaning should be repaired by qualified service technician.
Pump Body Removal.
1.Unplug the spray gun.
2.Loosen and remove the suction tube side at taching screws (Fig.1)
3.Remove the pump piece.
4.Separate the nozzle and valve and remove the piston from the cylinder with a suitable
piece of wood.
5.Clean all parts with solvent, the dry and lightly oil them.
6.Assemble the pump body in the reverse order of removal.
Summary of Contents for BPG7000
Page 6: ...6 www BormannTools com ...
