EN
WWW.BORMANNTOOLS.COM
2
Warning!
Important Safety Information
Failure to read these warnings may result in personal injury or vehicle damage.
Do not overload jack stands beyond their rated capacity!
Overloading can cause damage to or failure of the jack stands.
Position load on centre of saddle always using stands in pairs, on hard, level surface capable of sustaining the load.
Using stands on other than hard, level surfaces can result in instability and possible loss of load.
Operation
1. Refer to your vehicle owner’s manual for proper jacking lift point.
This area of the vehicle is specified by vehicle manufacturer.
2. Position stands under vehicle at points specified by vehicle manufacturer as proper load support points.
3. To adjust stands hold control lever up while lifting saddle shaft to desired height. Push control lever down to lock pawl into
teeth located in centre column. Make sure pawl is fully engaged into teeth.
4. Carefully lower load onto stands. Warning! Set both jack stands to the same height.
Maintenance & Inspection
1. Visual inspection shall be made before using the stands.
Check for cracked welds and missing and/or damaged parts.
A stand that appears to be damaged must be removed from service immediately.
2. Do not use Jack stands as a long-term stand for the vehicle.
Use them only while making repairs, then immediately lower vehicle to the ground.
Technical Data
BWR5025
Max Lifting Capacity:
2
Ton
Working distance:
95-365mm
Weight:
3Kg
* The manufacturer reserves the right to make minor changes to product design and technical specifications without prior notice unless these changes signif
-
icantly affect the performance and safety of the products. The parts described / illustrated in the pages of the manual that you hold in your hands may also
concern other models of the manufacturer’s product line with similar features and may not be included in the product you just acquired.
* Please note that our equipment has not been designed for use in commercial, trade or industrial applications. Our warranty will be voided if the machine is
used in commercial, trade or industrial businesses or for equivalent purposes.
* To ensure the safety and reliability of the product and the warranty validity, all repair, inspection, repair or replacement work, including maintenance and
special adjustments, must only be carried out by technicians of the authorized service department of the manufacturer.
Technical Data
BWR5026
Max Lifting Capacity:
3
Ton
Working distance:
95-365mm
Weight:
3
.2
Kg
