5
www.BormannTools.com
GB
Please do not keep emergency key
s in your safe!
*
Please take time to read and familiarize yourself with the proper operating procedures of your new safe presented on the
following pages.
Schematic drawing of
safe
1.
Bolts
2.
Reset Button
3.
Battery Compartment
4.
Knob (Master Key)
5.
Emergency Lock Cover
6.
Green Light
7.
Red Light
8.
Yellow Light
9.
Confirming button
10.
Power supply: 4 X 1.5V Batteries
CAUTION: All drawings in this manual have been prepared based on the EA. The exterior design or component positions
of other models may be different from what is indic
ated in the drawings, while the
operation is the same.
Opening your safe for the first time
Upon first opening, users should open the safe with t
he emergency key. The operation
in details refers to “opening the safe with
the emergency key”.
● Remove emergency lock cover, then insert the e
mergency key, and turn it count
clockwise.
● Turn the knob (master key) clockwise to open the door.
CAUTION: Finish operation, pull out the emergency key and keep it in a safe
place
.
Inserting the batteries
● Open the door.
● Insert 4 X 1.5V batteries into the battery compartment.
● Under normal condition, if
both of the red and the
green lights are on at the same
time, it means the voltage is low and you
should insert new batteries.
CAUTION: Replace 4 fresh batteries by lining them up in a manner as indicated by the “+ ” and “ - ” signs. When outage
for longer
than thirty minutes, you should
reset the user`s code.
Opening door
● Input your user’s code (3 to 8 digits), each pressing results one buzzer beep and
yellow light flashes.
● Press “A” or “B” (“C” or “E”) button, the green light will be on.
● Rotate the knob (master key) clockwise and pull outwards within 5 seconds, the
door is opened.
CAUTION: The user preset code “159”. Please input the user code again if the yellow light flashes with three buzzer
beeps.
Technical Data
Size:
46*39*36CM
Door board
thickness:
1.5MM
Weight:
17Kgs
