6
www.BormannTools.com
Closing door
● Turn the knob (master key) counter clockwise to close the door.
Automatic lock
● 3 continuously wrong entries will activate the warming beep for 20 seconds.
● Another 3 continuously w
rong entries wil
l active the warming beep for 5
minutes.
CAUTION: The key pad would be disabled during the beeping. You can only stop the beeps by opening the safe with
emergency key and power-cut by removing the battery
Setting the user code
● With the door open, press the reset button one, sta
rt setting code when the yellow
lights goes on.
● Input new code (3
-
8 digits), and press the “A” or “B”
(“C” or “E”) button to confirm
with 2 buzzer beeps, which indicates the
acceptance and storage of the new code.
● If the yellow light flashes with 3 buzzer beeps, w
hich means the code changing is
not effective, and you need to try again.
Setting master code
● Open the safe, input “0” twice and press reset butt
on, start setting code when the
yellow light goes on.
● Input the new master code (3
-
8 digits), then press “A” or “B” (“C” or “E”) button to
con
firm, it will be confirmed by 2 beeps and
the yellow light flashes two times, then
setting is done successfully.
● If the yellow light flashes three times, it means the
new code is invalid and should
operate again.
Opening the safe with the emergency key
Upon first receipt of the safe, or either the electronic circuit malfunction or codes
unknown. You could also use the emergency key
to open the safe.
● Remove the cover of the emergency lock.
● Insert the emerge
ncy key, turn it count clockwise, then turn the
knob (master key)
clockwise to open the door.
