4
support@borrowedspaces.com
Instructions for Proper Maintenance
Your Borrowed Spaces structure is designed and constructed of quality materials. As with all outdoor
products it will weather and wear. To maximize the enjoyment, safety and life of your structure it is
important that you, the owner, properly maintain it.
Symbols:
Throughout these instructions symbols are provided in the top, right-hand corner of the page.
If you dispose of your Borrowed Spaces structure:
Please disassemble and dispose of your
unit so that it does not create any unreasonable hazards at the time it is discarded. Be sure to
follow your local waste ordinances.
HARDWARE:
• Check metal parts for rust. If found, sand and repaint using a non-lead paint complying with 16
CFR 1303.
•
Inspect and tighten all hardware after completion of assembly; after first month of use; and then
annually. Do not over-tighten as to cause crushing and splintering of wood.
• Check for sharp edges or protruding screw threads, add washers if required.
WOOD PARTS:
• Applying a water repellent or stain (water-based) on a yearly basis is important maintenance to
maintain maximum life and performance of the product.
• Check all wood members for deterioration, structural damage and splintering. Sand down
splinters and replace deteriorated wood members. As with all wood, some checking and small
cracks in grain is normal
• Some gapping may occur at some wood connections.
CANOPY:
• Canopy must be removed when not in use and prior to heavy winds and snow.
•
To prevent potential collapse of support structure, DO NOT allow water, snow or debris to collect
on to of canopy.
•
Tape Measure
• Standard or Cordless Drill
• 7/16”, 1/2” Wrench
• 7/16”, 1/2” Socket
• #2 Phillips Driver
Assembly Guides
• 6’ Step Ladder x 2
• Safety Glasses
• Adult Helper
• Safety Gloves
Tools Required:
• Use Help, where this is shown, 2, 3 or 4
people are required to safely complete
this step. To avoid injury or damage to the
assembly make sure to get some help.
• Use a measuring tape to assure proper
location
• Pre-drill a pilot hole before fastening
screw or lag to prevent splitting of wood.
• Square
• Carpenters Level
• Ratchet
• Hard Hat
• Check that assembly is square before
tightening bolts
