37
WORK
2.
Lower the central brush, using the lever (3) on the control panel
WARNING
: The central brush will start to rotate as soon as it reaches its work position.
3.
Start the vacuum, turn the lever (4) left
WARNING!
When working on a wet area or if wet dirt is being collected, the vacuum
motor should be switched off by turning the lever (6) to the right, and once the critical
zone has passed the vacuum motor can be started again.
4.
Press the accelerator pedal (5) to start moving the machine
WARNING:
Adjust the working speed according to the amount of waste and debris
to be collected
To make a reverse manoeuvre, push the accelerator pedal (6) downwards, the machine will begin to
move backwards.
WARNING!
The reverse speed is lower than the forward speed to comply with
current health and safety standards.
If the dirt level requires it, lower the right side brush, (1SL versions) using the lever (7) on the control
panel. If you want to lower the optional left brush (2SL versions), use the lever (8)
WARNING:
Use the side brush or brushes (according to machine version) only on
edges, as it is not assisted by the vacuum action.
WARNING:
Both the central brush and the side brush will begin rotating as soon as
they are in their work position.
In order to achieve a correct vacuum action, clean the filter every 10 minutes and always before any
discharge of the debris hopper. To do this, proceed as follows:
1.
Stop the machine and engage the parking brake
2.
Raise the central brush, using the lever (1) on the control panel
3.
Raise the side brush or the side brushes if lowered, using the lever (2) for the right brush and the lever
(3) for the left brush on the control panel
3
4
5
6
8
7
1
3
2
