4
2. INSTALLATION & OPERATION GUIDELINES
An accredited competent person must carry out the installation of this appliance; All guidelines
set out in Section F, J & L of the Building Regulations 2014, Technical Guidance Document F, J & L
– Heat Producing Appliances MUST BE ADHERED TO.
Boru Stoves cannot accept responsibility for any fault arising through incorrect use or installation.
It is the responsibility of the stove installer & owner to be aware of any amendments to the above
document & amend the installation accordingly to comply with the most current version of the
above document. Failure to adhere to these guidelines may result in serious injury or even death.
Please hand these instructions, checklist and extended warranty sheet to the stove owner when
the installation is complete & ensure the stove owner has complete understanding of the working
& maintenance of the appliance. Please advise the stove owner to read this manual in full. Failure
to do so may result in serious injury or even death.
2.1 UNPACKING AND READYING THE STOVE FOR INSTALLATION
Handling – Health & Safety Precaution – Please ensure that you have made the adequate
facilities and made suitable lifting aids available for the safe unloading and site handling of
your Carraig Mor 20kW Boiler Stove, as this stove weighs over 150kg packaged.
Remove packaging from around the stove.
Disposal/Recycling of the packaging must be done in accordance with Health & Safety
Regulations.
Check the exterior of the stove and glass – Any damages and/or breakages MUST be
reported within 72 hours of delivery.
Check the body of the stove for any damage or defect – Any damage or defect must be
reported within 72 hours of delivery.
DO NOT INSTALL A DAMAGED OR DEFECTIVE STOVE.
It is required that the stove be installed by an experienced and accredited stove installer
that is familiar with Boru Products, contact the local authorised dealer for advice.
Open the door and check that the following parts are present, any shortages must be
reported within 72 hours of delivery –
Multi Tool Handle –See page 5 for diagram
Flue Collar – See page 5 for diagram
Baffle Plate – See page 5 for diagram
Flue Blank – See page 5 for diagram
In the unlikely event that any of these parts are missing please contact the local authorised
dealer with the CE plate number – See page 5 for diagram.
