9
8
Hydraulic stop adjustment
The Idylle 39 FCV is equipped with a hydraulic end stop that can be adjusted in 4 posi�ons at 10mm intervals. This allows you to
choose the start of ac�on of the hydraulic stop on your damping stroke. To change the posi�on of your end stop, follow the
instruc�ons below:
1
2
Unscrew the screws of the upper crown
with a 5mm Allen key
•
Remove the upper crown followed by
the elastomer frame stops
•
Unscrew the lower crown screws and
remove the lower crown/pivot assembly
•
Be sure to note the height of the
SETTINGS
•
Unscrew the cartridge bleed screw
and allow the air to escape before
replacing it
•
Unscrew the hydraulic cartridge with
a 26mm socket
3
•
Drain the content of the hydraulic
cartridge in an oil pan
•
Leave to drain a few moments
•
Screw the high speed compression
se�ng 1 all the way in, so that the stop
screw is released
5
6
•
Unscrew the locking screw 2
•
Remove the high speed compression
adjustment knob 1
•
Then unscrew the lower nut 3 and
remove it
SETTINGS
•
Carefully
remove
the
hydraulic
cartridge from the fork tube
•
Then place the cartridge on your
workbench
7
•
Clean the rod with a clean cloth before
disassembly
•
Unscrew the compression stop so as
to release the retaining ring
26mm Socket
14/16mm flat wrench
•
Once unscrewed, the compression stop
releases the retaining ring in posi�on
•
Move the snap ring to the desired stop
posi�on from 1 to 4: start of ac�on
furthest to closest
•
Be careful not to damage the rod
and the hydraulic stop
•
Degrease
the
parts
before
reassembly
Be careful not to damage the rod
and the hydraulic stop
4
8
Douille 21mm
