While wearing leather gloves (or any other gloves suitable for handling broken glass), carefully remove any loose pieces of glass from
the doorframe. Dispose of all broken glass properly. Return the damaged door to your Dealer for repair or replacement.
Neither the appliance owner nor any other unauthorized person(s) should replace the door glass. An authorized dealer must perform
all repairs involving door glass.
REMOVAL AND REPLACEMENT OF BROKEN DOOR GLASS
STOVE SHUTS OFF AND THE #2 LIGHT FLASHES
There should be a 5-volt current (approximately) going to the
air switch after the stove has been on for 30 seconds.
To test the air switch, you will need to disconnect the air hose
from the body of the stove. With the other end still attached
to the air switch, very gently suck on the loose end of the hose
(you may want to remove the hose entirely off the stove and
the air switch first and make sure it is clear). If you hear a click,
the air switch is working. BE CAREFUL, TOO MUCH VACUUM
CAN DAMAGE THE AIR SWITCH.
Possibles Causes
Possibles remedies (Unplug stove first when possible)
1.-Airflow switch hose or stove attachment pipes for
hose are blocked.
2.-The air inlet, burnpot, interior combustion air chambers,
combustion blower, or exhaust pipe are blocked with
ash or foreign material.
3.-The firebox is not properly sealed.
4.-Vent pipe is incorrectly installed.
5.-The airflow switch wire connections are bad.
6.-The gray wires are pulled loose at the Molex connector
on the wiring harness.
7.-Combustion blower failure.
8.-Control board not sending power to combustion
blower.
Unhook air hose from the air switch and blow through it. If
air flows freely, the hose and tube are fine. If air will not flow
throw the hose, use a wire coat hanger to clear the blockage.
Follow all cleaning procedures in the maintenance section of
the owner’s manual.
Make sure the door is closed and that the gasket is in good
shape. If the ash door has a latch, make sure the ash door is
properly latched and the gasket is sealing good. If the stove
has just a small hole for the ashes to fall through under the
burnpot, make sure the slider plate is in place to seal off the
firebox floor.
Check to make sure vent pipe installation meets criteria in
Owner’s Manual.
Check the connectors that attach the gray wires to the air
switch.
Check to see if the gray wires are loose at the Molex connector.
With the stove on, check to see if the combustion blower is
running. If it is not, you will need to check for power going
to the combustion blower. It should be a full current. If there
is power, the blower is bad. If there is not, see #8.
If there is not current going to the combustion blower, check
all wire connections. If all wires are properly connected, you
have a bad control board
9.-Control board not sending power to air switch.
10.-Air switch has failed (very rare)
OWNER´S MANUAL
-24-
TROUBLESHOOTING GUIDE
When your stove acts out of the ordinary, the first reaction is to call for help. This guide may save time and money by enabling you to solve simple
problems yourself. Problems can be caused by to only five factors: 1) poor fuel; 2) poor operation or maintenance; 3) poor installation; 4) component
failure; 5) factory defect. You can usually solve those problems related to 1 and 2. Your dealer can solve problems relating to 3, 4, and 5.
Summary of Contents for SPIRIT 500 Pellet
Page 22: ...OWNER S MANUAL 21 ...
