28
| English
0 276 001 XXX | (17.1.11)
Bosch ebike Systems
To
change the assistance mode
, press the
“mode”
button
4
until the desired mode is dis-
played in indicator
e
.
Adjusting the Assistance Level
In the set assistance mode, the assistance level
can be adjusted anytime, even during riding.
Note:
For individual versions, it is possible that
the assistance level is pre-set and cannot be
changed.
A maximum of three assistance levels as well as
the assistance shut-off are possible.
To
increase the assistance level
, press the
button
6
until the desired level is displayed in in-
dicator
c
.
To
decrease the assistance level
, press the
button
7
until the desired level is displayed in in-
dicator
c
.
In assistance level
“0”
, the drive is switched off.
The eBike can be operated as a normal bicycle
through pedaling.
Switching the Lighting On/Off
Depending on country-specific regulations, two
lighting versions are possible:
– The front light, rear light and display lighting
can be switched on and off at the same time
via the drive HMI.
– Only the display lighting can be switched on
and off; the front and rear light of the eBike
are independent of the drive HMI.
For both versions, the
lighting is switched on
by
pressing the
“light”
button
5
. The lighting indi-
cator
b
appears on the display.
To
switch off the lighting
, press the
“light”
but-
ton
5
again; the lighting indicator
b
goes out.
Speed and Distance Indicators
Note:
Depending on country-specific version,
distance and speed can either be displayed in
“km”
and
“km/h”
or in
“mi”
and
“mph”
. Adjust-
ment of the drive HMI and the selection of the
display possibilities for the km and mile version
are identical.
The
speed indication
a
always displays the cur-
rent speed.
The following indications are available in
multi-
function indicator
d
:
Total distance
“odo”
: Indi-
cates the total distance cov-
ered with the eBike
Trip distance
“trip”
: Dis-
tance covered since the last
reset
Average speed
“avg”
: Aver-
age speed achieved since
the last reset
Range
“range”
: Estimated
range of the available bat-
tery charge (for constant conditions such as
assistance mode, assistance level, route profile
etc.)
To
switch within the multi-function indicator
,
press the
“info/reset”
button
3
until the desired
function is displayed.
To
reset
the trip distance
“trip”
and the average
speed
“avg”
, switch to one of both indications
and then press the
“info/reset”
button
3
until
the indication is reset to zero.
“SPORT”
: Powerful assistance for
sportive riding off road as well as
for urban traffic
“SPEED”
: Maximum assistance,
supporting highest cadence for
sportive riding
Assistance
degree* at:
Assistance level
Assistance mode
“1”
“2”
“3”
“ECO”
30 %
60 %
90 %
“TOUR”
50 %
100 %
160 %
“SPORT”
55 %
110 %
200 %
“SPEED”
60 %
130 %
250 %
* The assistance degree can vary for individual versions.
OBJ_BUCH-1407-001.book Page 28 Monday, January 17, 2011 2:58 PM
