66
Bosch Rexroth AG
Safety instructions
ES+CC-ES.book Seite 72 Montag, 14. Mai 2018 7:45 07
ErgoSpin/CC-ErgoSpin
| 3608870H86/2020-01
The dust produced by sanding, sawing,
grinding, drilling and other similar
activities may cause cancer, congenital
defects or genetic mutations.
Some of these dusts contain substances such
as: Lead in lead-based paint and varnish;
crystalline silica in bricks, cement and other
building materials; arsenic and chromate in
chemically treated wood. The risk of becoming
ill depends on how frequently you are exposed
to these substances. To reduce the potential
danger, you should always wear adequate
personal protective equipment (e.g. specially
made breathing apparatus that can filter out
even the smallest of dust particles) and work
only in well-ventilated areas.
WARNING
Do not use application tools that are worn
or in otherwise less than perfect
condition.
Defective application tools can
break, for example, causing material
damage and personal injury.
When fitting an application tool, make
sure that it is held securely in the tool
holder.
If the application tool is not held
securely in the tool holder, it may become
loose and consequently uncontrollable.
Be careful when screwing in long screws -
there is a risk of slipping when using
particular screws and application tools.
Long screws are often difficult to control and
there is a danger that you will slip and hurt
yourself when screwing them in.
Check which rotational direction is set
before switching on the power tool.
If you
want to loosen a screw but the rotational
direction is set to tighten the screw, for
example, the power tool may move violently
and uncontrollably.
Observe all notes on the electric tool.
Observe the safety regulations of the
country in which the electric tool is used/
operated.
Observe the applicable accident
prevention and environmental protection
regulations.
Observe the technical data and ambient
conditions specified in the product
documentation.
Only use an electric tool if this use is
expressly specified and permitted in the
documentation of the product.
If
unsuitable electric tools are installed or used
in safety-relevant applications, unintended
operating states may occur in the application
that may cause personal injuries and/or
damage to property.
Use electric tools only when they are in
good technical order and condition.
You may only commission the electric tool
if it has been determined that the end
product (e.g., machinery or a system) in
which the Rexroth products are installed
complies with the country-specific
conditions, safety regulations and
standards of the application.
