82
Bosch Rexroth AG
Operation
•
If the torque threshold (basic setting: 5% of
the nominal torque of the hand-held
nutrunner) was not exceeded, there will be no
evaluation. The system interprets this process
as "Play at start switch" and ignores it.
•
If the initial torque was exceeded, tightening is
evaluated as faulty (NOK) and the red LEDs
are illuminated.
If the ErgoSpin/CC-ErgoSpin hand-
held nutrunner is used as a stationary
tightening spindle, the start switch
must be continually actuated. Lock
the start switch on the ErgoSpin/CC-
ErgoSpin hand-held nutrunner using
the velcro tape.
ES+CC-ES.book Seite 88 Montag, 14. Mai 2018 7:45 07
ErgoSpin/CC-ErgoSpin
| 3608870H86/2020-01
8.4
Tool button
Push the tool button to acknowledge.
On delivery, the tool button is con-
figured such that NOK tightening must
be acknowledged with the button.
Further tightening processes can only
be started after this
acknowledgement.
The function of the tool button can be changed
via the PLC assignment table (control signals) in
the operating system, e.g. BS350 or BS350 CC-
ES (until the BS350 standard with V2.400 has
been introduced).
