MY22Z0a - 12_1.0_25.07.2022
118
Operation
6.5.6.5 Setting the quill stem
Only applies to pedelecs with this equipment
In the case of a quill stem, the stem and fork
steerer form a permanently interconnected
component, which is clamped in the fork steerer.
The stem and shaft must be replaced together.
Figure 127: Adjusting the quill stem height
1
Undo screw.
2
Pull quill stem out.
3
Tighten screw.
6.5.6.6 Adjusting the Ahead stem
Only applies to pedelecs with this equipment
In the case of an Ahead stem, the stem is placed
directly on the fork steerer, which protrudes over
the frame.
Figure 128: Raising the Ahead stem by fitting spacer rings
The handlebar height is adjusted once during
production using spacer rings. The part of the fork
steerer protruding is then cut off. The handlebar
stem can then no longer be set higher, but only
slightly lower.
Summary of Contents for 22-15-2061
