Bosch 3601E29600 Original Instructions Manual Download

Page: 12 / 189

| English

The vibration level and noise emission value given in these
instructions have been measured in accordance with a
standardised measuring procedure and may be used to com-
pare power tools. They may also be used for a preliminary
estimation of vibration and noise emissions.
The stated vibration level and noise emission value repres-
ent the main applications of the power tool. However, if the
power tool is used for other applications, with different ap-
plication tools or is poorly maintained, the vibration level
and noise emission value may differ. This may significantly
increase the vibration and noise emissions over the total
working period.
To estimate vibration and noise emissions accurately, the
times when the tool is switched off or when it is running but
not actually being used should also be taken into account.
This may significantly reduce vibration and noise emissions
over the total working period.
Implement additional safety measures to protect the oper-
ator from the effects of vibration, such as servicing the
power tool and application tools, keeping their hands warm,
and organising workflows correctly.

Rechargeable battery

Bosch

sells some cordless power tools without a re-

chargeable battery. You can tell whether a rechargeable bat-
tery is included with the power tool by looking at the pack-
aging.

Charging the battery

Use only the chargers listed in the technical data.

Only

these chargers are matched to the lithium-ion battery of
your power tool.

Note:

Lithium-ion rechargeable batteries are supplied par-

tially charged according to international transport regula-
tions. To ensure full rechargeable battery capacity, fully
charge the rechargeable battery before using your tool for
the first time.

Inserting the Battery

Push the charged battery into the battery holder until it
clicks into place.

Removing the Battery

To remove the rechargeable battery, press the battery re-
lease button and pull the battery out.

Do not use force to do

this.

The rechargeable battery has two locking levels to prevent
the battery from falling out if the battery release button is
pressed unintentionally. The rechargeable battery is held in
place by a spring when fitted in the power tool.

Battery charge indicator

The green LEDs on the battery charge indicator indicate the
state of charge of the battery. For safety reasons, it is only
possible to check the state of charge when the power tool is
not in operation.

Press the button for the battery charge indicator or

show the state of charge. This is also possible when the bat-
tery is removed.
If no LED lights up after pressing the button for the battery
charge indicator, then the battery is defective and must be
replaced.

Battery model GBA 18V...

LED

Capacity

3× continuous green light

60–100 %

2× continuous green light

30–60 %

1× continuous green light

5–30 %

1× flashing green light

0–5 %

Battery model ProCORE18V...

LED

Capacity

5 × continuous green light

80–100 %

4 × continuous green light

60–80 %

3 × continuous green light

40–60 %

2 × continuous green light

20–40 %

1 × continuous green light

5–20 %

1 × flashing green light

0–5 %

Recommendations for Optimal Handling of the
Battery

Protect the battery against moisture and water.
Only store the battery within a temperature range of −20 to
50 °C. Do not leave the battery in your car in the summer, for
example.
Occasionally clean the ventilation slots on the battery using a
soft brush that is clean and dry.
A significantly reduced operating time after charging indic-
ates that the battery has deteriorated and must be replaced.
Follow the instructions on correct disposal.

Operation

Starting Operation

Switching On and Off

switch on

the power tool, slide the on/off switch

(3)

for-

wards so that

appears on the switch.

switch off

the power tool, slide the on/off switch

(3)