Remote control installation
6 720 680 078
(2011/09)
15
4.2
Remote control activation
B
Connect power to heater.
B
Press ON / OFF button on the appliance to OFF.
B
On heater control panel, press and hold Program key
while pressing the ON/OFF button to ON.
Release program key when LCD displays "188".
LCD shows “P2”. If not, repeat previous step.
B
Press the
button on the heater to select "P3".
B
Press and hold Program key
again for 1 sec.
LCD shows one number and one rotating digit. If
not, repeat previous step.
The number represents the remote control which is
to be registered, the first remote control will be reg-
istered with number “0”, the second with number
“1” and so on.
The rotating digit shows that the electronics is
expecting a registration. If the LCD fails to show a
number and rotating digit after repeated attempts,
double check the wire connections.
B
Hold remote control in front of the control panel on
the heater and simultaneously press remote control
buttons
and
until the temperature indication
is shown on the remote control LCD.
B
Press ON / OFF button on the appliance to OFF
position and then back ON.
B
Press buttons
or
to reach desired tempera-
ture.
New remote control is programmed.
Before the remote control will work, it
must be activated using the procedure
described below with the operator
standing in front of the appliance.
+
