Installation & Operation Manual
Bosch ZS Series Zone Sensors R1
| 11
Bosch Thermotechnology Corp.
|
02 .2018
Data subject to change
9.3 To Make the Zone Warmer or Cooler Using a ZS Push/Manager
1.
From the Home screen, press the
or
button to show the Setpoint
Adjustment screen. The screen shows the following: (Figure 4)
Figure 4
Cooling setpoint
Heating setpoint
Zone temperature
2.
Press the
or
button to adjust the zone temperature setpoint. The
control program determines how much you can adjust the setpoint and
is default to +/- 3°F. The DDC Control Air 5600, 5830, or 6120 control
program allows this adjustment value to be changed either using a Control
Air M or M+ interface, legacy BACview, or from an available BAS. The
maximum allowable setpoint adjustment from the space is +/- 9 °F.
3.
Any setpoint adjustments made during an occupied session are cleared
each time the unit transitions from occupied mode to unoccupied mode,
and the setpoint adjustment remains at 0 until the next manual adjustments
in the space.
4.
Wait a few seconds until the display returns to the home screen before you
press any other buttons
9.4 To Override the Schedule Using a ZS Push/Manager
Timed Override to an Occupied State
1. Press
the button one time to override the schedule and put the zone in an
occupied state for a length of time specifi ed in the control program.
2. Press
the button repeatedly to incrementally increase the time. The time
increases in increments of 30 minutes and the maximum length of time that
the override may be scheduled is 180 minutes (3 hours).
3.
To cancel an override and return control to the schedule, press the
button twice.
4.
Wait a few seconds until the display returns to the home screen before you
press any other buttons.
During the override, the bottom of the display shows the time (minutes) remaining in
the override and an hourglass to indicate the override state.(See Figure 5)
Figure 5
Force to an Occupied State
1.
Press and hold the
button for 3 seconds to force the zone to an
unoccupied state.
2.
To cancel the force to unoccupied and return control to the schedule, press
the
button again.
