162
en | Card Reader Keypad Functions
Access Easy Controller
Ver 2.0.0 | 2006.07
Hardware Manual
Bosch Security Systems
4.
The
key is used in order for the system to capture the clock-out times of the card-
holders (employees only).
5.
The
or
key is used to terminate an entry.
6.
The
or
key is used to cancel/quit any changes made.
7.
The
key is used together with an arming card to arm alarm zones.
21.2
Entry Operation
The following sections highlight the various means to enter and exit a controlled area using
the keypad. These functions MUST be enabled in the Card Reader parameter setting before it
could be used. Refer to the AEC Software manual for details in enabling these functions.
21.2.1
Using Card + PIN mode on a Keypad Reader
To gain access, follow the procedures: -
1.
Present the card to the Reader, the LED flash at a slow rate for the duration as depicted
in the Reader's Keypad Timeout field.
2.
Enter your PIN code (followed by the
or
key, if it is less than 7 digits). If the
PIN code is valid, pull the door to get in. Otherwise, the LED will flash at a fast rate, indi-
cating a wrong PIN code.
21.2.2
Using Keypad in the Enable Keypad Only Operation mode
If the Enable Keypad Only Operation mode is activated, all users can either gain access by pre-
senting card or by entering their card number using the
key. However, if the card(s) is
set in Card and PIN operation AND the door required PIN code for entry, user(s) has to enter
their card number followed by their assigned PIN code before access is granted.
Manual Card Entry without PIN code
1.
First, press the
key, The LED flash continuously at a slow rate for the duration as
depicted in the Keypad Timeout field.
