Access Easy Controller
Is Access Easy Controller the Correct Choice for Your
Client? | en
19
Bosch Security Systems
Hardware Manual
Ver 2.0.0 | 2006.07
X
An IP address for the controller.
X
The subnet mask that is used on the network (or sub-network) to which the Access Easy
Controller will be connected.
X
If the controller will need to go through a gateway to communicate over the network,
then the IP address of the gateway will be needed.
X
Also, if the e-mail feature is to be used, then IP Address of the SMTP mail server will be
required.
Request this information from the customer and record it below.
Controller IP address:_ _ _ _. _ _ _ _. _ _ _ _. _ _ _ _
Subnet mask:_ _ _ _. _ _ _ _. _ _ _ _. _ _ _ _
Gateway address:_ _ _ _. _ _ _ _. _ _ _ _. _ _ _ _
Outgoing SMTP mail server:_ _ _ _. _ _ _ _. _ _ _ _. _ _ _ _
Outgoing mail server port:_ _ _ _
Controller's E-mail account name and domain:_ _ _ _. _ _ _ _. _ _ _ _
Finally, note the following information that will be needed by the installer.
X
Location where the Access Easy Controller is to be installed:
X
Location of the wall jack or hub to be used by the controller to connect to the customer's
network:
4.2
When the network does not meet the requirements of Access
Easy Controller
The following paragraphs provide expanded discussion of network items that were identified
as not compatible with Access Easy Controller during completion of the network survey.
For each item, at least one solution will require hardware or software changes within the cus-
tomer's computer. These modifications should always be done by customer, their IT depart-
ment, or their supplier of IT hardware and systems. Bosch Security systems personnel should
not modify the hardware and/or software configuration of customer's computer.
