82
en | Configuring a Web Browser to Work with Access Easy Controller
Access Easy Controller
Ver 2.0.0 | 2006.07
Hardware Manual
Bosch Security Systems
6.
Enter the default IP address of the Access Easy Controller in box List the sites you want
to connect to directly at the bottom of the screen as shown in the sample screen above.
7.
If the permanent IP Address of the Access Easy Controller is different from the default
address, then also enter the controller's permanent address in the List the site box, sep-
arating each address with a space or comma.
8.
Note that there may already be IP addresses listed in this box. If that is the case, simply
add the Access Easy Controller address to the list, separating each address with a space
or comma. The sample box shown at the top of the next page shows the default IP
Address for Access Easy Controller along with three other IP Addresses (129.2.0.45,
129.2.0.44, and 129.3.0.80).
9.
Click OK to close the dialog box.
10. Make sure you have a crossover type network cable connected between the computer
and the Access Easy Controller. If the Web browser is not running start it at this time.
i
NOTICE!
You may receive a warning indicating that the page you are trying to reach is not available.
This message is shown on the drawing below. Do not be concerned with this message at this
time.
