1 689 988 238
2012-11-06
|
Robert Bosch GmbH
100 | ACS 651/751 | Program description
en
6.5.2
Selecting the vehicle from the list of 10 ve-
hicles serviced previously
i
Before starting the service, refer to chapter 6.4.
!
Use only new oil to replace the quantity removed
during the recovery process. Used oil should be
discarded as per applicable federal, state and local
requirements.
i
There will be no vehicles listed in the
Last 10 ve-
hicles
screen before performing the first vehicle A/C
service.
1.
Connect the power cable to the mains supply.
2.
Turn on the master switch.
3.
In the main menu, select
"Vehicle A/C Service"
and
press
E
.
4.
Select the operator name and press
E
. For
ACS 651, select the service type - quick service or
precision service - and proceed to step 5.
5.
Check the type of vehicle being serviced - hybrid or
non-hybrid.
6.
Check if the correct fresh oil bottle - PAG or POE - is
connected.
i
If you are switching from a hybrid vehicle to a non-
hybrid vehicle or vice versa, perform flushing. Refer
to chapter 6.8 for more information on flushing.
7.
Select
"Automatic Mode"
and press
E
.
8.
Select
"Last 10 vehicles"
.
9.
Press
E
.
The list of 10 vehicles that were previously ser-
viced is displayed.
10.
Press the
o
or
u
keys to scroll the list of the 10
vehicles that were recently serviced. If you wish to
perform A/C service on a vehicle listed among the
10 vehicles, select the vehicle and press
E
.
The automode service parameters are displayed.
11.
Press
E
.
12.
Check the type of connection on the vehicle A/C
system.
13.
Connect the appropriate coupler to the service
connection on the vehicle A/C system.
!
Do not use any tools to tighten the couplers.
14.
Press the
z
or
r
keys to select the type of con-
nection
.
i
If you select oil and/or UV dye recharge, it is not pos-
sible to select the option "
LP only
".
15.
Press
u
to navigate to the "
Vehicle ID (Plate Num-
ber)
" field. Enter the plate number of the vehicle.
16.
Press
u
to navigate to the "
VIN Number
" field.
Enter the VIN number of the vehicle
i
Check the oil quantity calculation - delta or absolute
- before you proceed with the service. Selecting the
wrong oil quantity calculation might damage the ve-
hicle compressor. To change the oil quantity calcula-
tion, refer to chapter 4.8.1.
Always pay attention to
the vehicle-specific info before changing the quantity
of oil.
