14
en | Connections
AMC2 enclosure with 1
DIN rail
2020-07 | V04 | F.01U.330.018
Bosch Security Systems B.V.
Mounting and connecting the power cable with LED indicator
(G)
Notice!
Use this cable (G) instead of cable F if you are installing a
system that is to be UL approved.
1.
Pass the cable end through the front of the LED bracket
hole (Figure 1, position 12).
2.
Carefully pull the cable through the back of the LED
bracket.
3.
Make sure that the LED reaches and fits the LED bracket
hole.
4. Connect the single brown wire to position 3, marked with L
(Figure 3.2).
5. Connect the other end from the brown wire to position 1,
marked with L1 (Figure 3.2).
6. Connect the single blue wire to the position 4, marked with N
(Figure 3.2).
7. Connect the other end from the blue wire to the position 2,
marked with N ( Figure 3.2).
Connecting the tamper contact (E)
1.
Mount the micro switch with two screws M2 x 10 mm
(Figure 1.1, position 6) at the right side of the enclosure.
2.
Connect the loose ends of the tamper contact cable to the
two-pin screw connector (marked with T) at the top of the
AMC2.
3.
Position the cable in the space between the housing and
the mounting rail.
Danger!
Risk of electric shock
Make sure that all wires have zero potential.
Summary of Contents for AEC-AMC2-UL01
Page 1: ...AMC2 enclosure with 1 DIN rail AEC AMC2 UL01 en Installation manual ...
Page 2: ......
Page 31: ......
