38
en | Camera
AUTODOME IP 4000i/AUTODOME IP 5000i/
AUTODOME IP 5000i IR
2018.05 | 1.1 |
User Manual
Bosch Security Systems
Pan limit right
Set the appropriate pan limit on the right.
Tour A / Tour B
Starts and stops the recording of a recorded (guard) tour.
The camera can make up to two (2) recorded tours. A recorded tour saves all manual camera
movements made during the recording, including its rate of pan, tilt and zoom speeds, and
other lens setting changes. The tour does not capture camera video during the recording of
the tour.
Note 1
: You can save a total of 15 minutes of recorded actions between the two tours.
To record a tour:
1.
Click the Start Recording button. The system prompts you to overwrite the existing tour.
2.
Click Yes to overwrite the existing tour movements.
3.
Click the View Control link, under the image cameo, to access the directional and zoom
controls.
4.
Use the View Control dialog box to make the necessary camera movements.
5.
Click the Stop Recording button to save all actions.
Note
:
Tour B
is now intended for use with the 'IVA while moving' functions.
Compass
The camera allows a user to display the compass heading of the camera in the lower-right
corner of the image display. The camera displays the cardinal or intercardinal (N, NE, E, SE, S,
SW, W, NW) heading in which the camera is pointing.
You must first calibrate the camera to North before the camera displays accurate compass
headings. The camera uses this calibration, usually set to magnetic North, as the zero degree
pan position and as the North compass heading. The camera then displays the compass
heading based on the number of degrees from the North calibration point.
To set the North calibration point:
1.
Determine the North compass heading, then move the camera to that position.
2.
Select the radio button
On
for the parameter
Compass
.
3.
Click the button next to
North point
to set the calibration point.
North point
–
Click the
Set
button to overwrite the existing
North point
. A dialog box appears with the
message, “Overwrite
North point
?” To confirm, click
OK
. To cancel, click
Cancel
.
–
Click the
Clear
button to reset the
North point
to factory defaults. A dialog box appears
with the message, “Reset
North point
to factory defaults?” To confirm, click
OK
. To
cancel, click
Cancel
.
6.13
Pre-positions and Tours
The camera can store up to 256 preset scenes. You can define the individual scenes that
comprise a
Pre-position
Tour
.
You define individual pre-position scenes, then use these scenes to define the
Pre-position
Tour
. The tour starts from the lowest scene number in the tour and progresses sequentially to
the highest scene number in the tour. The tour displays each scene for a specified dwell time
before advancing to the next scene.
By default, all scenes are part of the
Pre-position
Tour
unless removed.
To define and edit an individual pre-position:
1.
Set the pre-position in the video image.
–
Use the PTZ controls to move the camera into position.