62
en | Network
AUTODOME IP 4000i/AUTODOME IP 5000i/
AUTODOME IP 5000i IR
2018.05 | 1.1 |
User Manual
Bosch Security Systems
Notice!
Duplication of data places a heavy demand on the unit and can lead to impairment of the
image quality under certain circumstances.
Port
Assign a different port to each data stream if there are simultaneous data streams at the same
multicast address.
Enter the port address of the required stream here.
Streaming
Click the checkbox to activate multicast streaming mode for the relevant stream. An enabled
stream is indicated by a check mark.
Multicast packet TTL
You can enter a value to specify how long the multicast data packets are active on the
network. This value must be greater than one if multicast is to be run via a router.
10.7
Image Posting
You can save individual JPEG images on an FTP server at specific intervals. You can then
retrieve these images at a later date to reconstruct alarm events if required. In order to
configure image posting, and to save and retrieve JPEG images, you must create an Account in
which to save and access them. If you have not configured an account, the following error
message appears at the top of this page: “No configured account. Configure accounts.” Click
the link to access the Accounts page.
Image size
Select the appropriate image size: Small, Medium, Large, 720p, 1080p,
Best possible
.
File name
You can select how file names will be created for the individual images that are transmitted.
–
Overwrite
The same file name is always used and any existing file will be overwritten with
the current file.
–
Increment
A number from 000 to 255 is added to the file name and automatically
incremented by 1. When it reaches 255 it starts again from 000.
–
Date/time suffix
The date and time are automatically added to the file name. When
setting this parameter, ensure that the unit's date and time are always correctly set.
Example: the file snap011005_114530.jpg was stored on October
1,
2005 at 11:45 and
30
seconds.
VCA overlays
To include VCA overlays in the email, select this check box.
Posting interval
Enter the interval in seconds at which the images will be sent to an FTP server. Enter 0 (zero)
if you do not want any images to be sent.
The following field may or may not appear, depending on your camera:
Post JPEG from camera
Click the checkbox to select the cameras from which JPEG images are sent. An enabled video
input is indicated by a check mark.
Target
Select the target—the name of the account on the server—to which to save images.
When face recognition is available, selected images of the face can be sent to a target
account.
