AUTODOME IP starlight 7000i
Preparing the bubble | en
21
Bosch Security Systems
Installation Manual
2021-03 | 1.2 |
5
Preparing the bubble
i
Notice!
To avoid excessive moisture saturation inside the housing, limit the amount of time that the
bubble is disconnected from the housing. Bosch recommends that the bubble be removed
from the housing for no more than five (5) minutes.
Remove the bubble from a pendant housing
1.
Using both hands, apply a firm counterclockwise (looking up at the dome) rotational
force on the pendant bubble assembly to set the bubble latch.
2.
Insert a small (2 mm) straight blade screw driver into the release opening in the bubble
trim-ring to release the lock, and then remove the screwdriver.
Figure 5.1:
Remove the bubble
4
Firmly rotate the bubble counterclockwise approximately 20 degrees until the bubble
assembly releases from the pendant housing.
Summary of Contents for AUTODOME IP starlight 7000i NDP?7512?Z30
Page 1: ...AUTODOME IP starlight 7000i NDP 7512 Z30 NDP 7512 Z30K en Installation Manual ...
Page 2: ......
Page 71: ......