17
10. Removing stainless steel front panel
from the freezer compartment
drawer
̈
Loosen and unscrew nuts on the top of the door.
However, do not turn the threaded bolts, otherwise
the door will no longer be aligned.
̈
Do not loosen the screws on the left and right fixing
brackets.
Do not unscrew the screws!
̈
Pull the bottom of the stainless steel front panel away
from the door to remove the fixing brackets from the
screws. Then lift the door off the threaded bolts.
̈
Place fixing brackets only loosely into the plates.
Ensure that you do not lose them.
̈
Remove base panel from the appliance.
11. Aligning the appliance
̈
Align the appliance with the furniture fronts.
The height-adjustable feet at the front and rear can all be
adjusted from the front.
Front:
with open-ended wrench
1
/
2
" (SW13)
Rear:
with
5
/
16
" (8 mm) hex nut driver via flexible shaft.
A mark is attached to the appliance base and is used as a
standard gage for height adjustment. When adjusting the
height, align this mark at a height of 1
1
/
4
" (32 mm) above the
floor.
m
CAUTION
m
Never use a cordless screwdriver!
Risk of damage to the appliance.
NOTE
– Do not twist or jam the appliance inside the cavity!
When unscrewing the height-adjustable feet,
proceed gradually: Always alternate between left
and right, left and right, etc..
– The adjustment of the rear feet is facilitated if the
appliance is unloaded at the rear.
– If using a wooden beam as an alternative anti-tip
device according to point 6 of this installation
manual, rotate the appliance all the way towards the
wooden beam.
