19
13. Connecting the water to the
appliance
̈
Remove the cap from the appliance connection (
1.
).
̈
Bend the water pipe according to the location of the
connection on the appliance (
2.
).
̈
Push the union nut and seal onto the water pipe.
̈
Push the end of the water pipe into the appliance
connection and screw on the union nut (
3.
).
Tighten hand-tight.
̈
Using the open-ended wrench, tighten the union nut.
Do not overturn!
̈
Open the shut-off valve and main water tap. Check the
connection on the shut-off valve and on the appliance
for leaks.
14. Attaching the toe kick panel
̈
If required, cut the toe kick panel to the required length.
̈
Attach the base panel to the appliance.
̈
Remove the protective film from the adhesive pads on
the Velcro.
̈
Fit the toe kick panel to the base panel and press firmly
into place.
̈
Remove base panel from the appliance.
̈
Put on the base panel (do not screw on) and measure
the difference in depth
Y
between the base panel and
toe kick panel of the adjacent furniture.
̈
Remove the base panel.
̈
Loosen the brackets for attaching the base panel and
push in all the way.
m
CAUTION
m
When bending the water pipe, do not kink it, otherwise
there is a risk of leaks and water damage.
NOTE
When connecting the water pipe to the solenoid valve
of the appliance, follow the instructions supplied by the
manufacturer of the ice maker installation kit enclosed
with the installation manual.
m
CAUTION
m
The maximum height of the toe kick panel is 4" from the
top of the floor. Do not cover ventilation slots in the base
panel. Risk of damage to the appliance.