Electrical shock. Be aware of any and all electric lines and electric fences
Check all
areas for electrical lines before cutting.
8
STARTING THE MACHINE
Move at least 3 meters away from the place of refueling. Place
the Hedge Trimmer on a clean area of ground make sure that
the cutting tool does not come into contact with the ground or
any other objects Cold starting (When the engine is cold or it
has been stopped for more than 5 minutes or when fuel is
added to the engine )
1 Push the STOP switch (1) to “1”position
2 Squeeze first the lock lever A and then the throttle lever B
(fig 1)
3 Keeping the throttle lever B depressed,then press the throttle lock C inward (fig 2)
4 Keeping the throttle lever C depressed,
release the throttle lever B this will lock the
throttle lever B in position (fig 3)
5 Give a gentle push on the primer pump (2)
repeatedly (7 to 10 times) until fuel comes into
the primer pump
6 Move the choke lever (3) to position
→
open
7 Hold the unit down firmly so you will not lose
control while cranking the engine. If not held
down properly, the engine could pull you off
balance or swing the cutting blade into an
obstruction or your body.
8 Slowly pull the starter grip until resistance is felt
and continue with smart pull until initial ignition are
heard.
9 Depress the choke lever (3) to the position
close
←
and pull the starter rope again until the
engine starts.
10 As soon as the engine starts, immediately tap
and release the throttle
，
thus releasing the
half-throttle rock so that the engine can run in idle.
11 Run the engine for approximately one minute at a
moderate speed before applying full speed.
Hot starting
：
(Restarting immediately after the
engine has stopped)
When restarting a hot engine
，
first try the above
procedure
：
1
，
7
，
8
If the engine does not start
，
repeat above steps 1-11.
Note
：
Do not pull the starter rope to its full extent
and do not allow the starter grip to be retracted
without control
，
ensure that it is retracted slowly.
STOPPING THE MACHINE
1. Release the throttle lever completely.
2. Push the 1-O switch (on/off switch) to“O”position
，
the engine rotation will before low and the
engine will stop.
