9
OPERATION OF THE MACHINE
-
Be sure to carefully read and follow safety instructions.
-
Keep hands away from blades. Never grasp the exposed
cutting blade or cutting edges
，
when picking up or holding the
tool.
-
Never touch the cutting device when starting the engine and
during operation.
-
Operate the Hedge Trimmer in such a manner as to avoid
inhalation of the exhaust gases. Never run the engine in
enclosed rooms (Risk of gas poisoning). Carbon monoxide is
an odorless gas.
-
All protective installations and guards, supplied with the
machine must be used during operation.
-
Never operate the engine with a faulty exhaust muffler or if it
is missing.
-
Use the Hedge Trimmer only in good light and visibility.
Always ensure a safe footing.
-
Never stand on a ladder and run the Hedge Trimmer. Keep
both feet on the ground.
-
Never climb up the trees with the Hedge Trimmer to perform cutting operation.
-
Never work on unstable surfaces.
-
Remove sand, stone, nails,wire,etc. found within the working
area. Foreign objects may damage the cutting blades.
-
Before commencing cutting, the cutting blades must have
reached full working speed.
-
Always hold the Hedge Trimmer firmly with both hands one
handles only.
-
The right hand grip with thumbs and fingers encircling the
handles.
-
When you release the throttle
，
it takes a few moments before
the cutting blades stop.
-
The Hedge Trimmer must not be used for cutting with fast idle.
The cutting speed cannot be adjusted with the throttle control
in fast idle position.
-
When cutting a hedge
，
the machine should be held so that the
blades from a 15-30’ angle with the cutting line.
-
If the Hedge Trimmer is used with circular movements against
the edge of the hedge, the Hedge Trimmer is used with
circular
pendulation, swinging up and down close to the
hedge.
-
Pay special attention when cutting hedges which are laid out a
long a wire-fence and have grown through the fence.
The blade must not contact the fence, otherwise the blades
may be destroyed.
