en
Cleaning and servicing
20
3.
Close the locking levers.
4.
Close the appliance door.
12.8 Door panels
To make it easier to clean the door panels, you can re-
move the appliance door.
Removing the door panels
WARNING ‒ Risk of injury!
The hinges on the appliance door move when the door
is opened and closed, which could trap your fingers.
▶
Keep your hands away from the hinges.
Components inside the appliance door may have sharp
edges.
▶
Wear protective gloves.
1.
Open the appliance door slightly.
2.
Press on the left- and right-hand sides of the cover
.
3.
Remove the cover .
4.
Lift out the inner panel upwards and set it down on
a flat surface.
5.
To remove and clean the condensate trough, if re-
quired, open the appliance door fully.
6.
Tilt the condensate trough upwards and remove it.
7.
Clean the door panels with glass cleaner and a soft
cloth. Clean the condensate trough with a cloth and
hot soapy water.
Refitting the door panels
WARNING ‒ Risk of injury!
The hinges on the appliance door move when the door
is opened and closed, which could trap your fingers.
▶
Keep your hands away from the hinges.
Components inside the appliance door may have sharp
edges.
▶
Wear protective gloves.
Note:
You cannot use your appliance again until the
panels have been correctly fitted.
1.
Open the appliance door fully.
2.
Refit the condensation trough. To do this, insert the
condensate trough from above and rotate it down-
wards .
3.
Slide in the inner panel .
When doing this, ensure that the glossy side of the
panel is on the outside and the cut-outs on the left
and right are at the top.
The panel must be sitting correctly at the bottom in
the retainer.