en
Installation instructions
34
¡
Do not install the appliance behind a decor-
ative door or the door of a kitchen unit.
There is a risk of overheating.
¡
Cut-out work on the units should be carried
out before installing the appliance. Remove
any shavings. Otherwise, the correct opera-
tion of electrical components may be ad-
versely affected.
¡
The mains socket for the appliance must
either be located in the hatched area or
outside of the area where the appliance is
installed.
Any unsecured units must be secured to
the wall using a standard bracket .
¡
Wear protective gloves so that you do not
cut yourself. Parts that are accessible dur-
ing installation may have sharp edges.
¡
Dimensions of the figures in mm.
WARNING ‒ Danger: Magnetism!
Permanent magnets are used in the control
panel or in the controls. They may affect elec-
tronic implants, e.g. pacemakers or insulin
pumps.
▶
Wearers of electronic implants must stay at
least 10 cm away from the control panel or
controls during the installation.
WARNING ‒ Risk of fire!
It is dangerous to use an extended power
cord and non-approved adapters.
▶
Do not use extension cables or multiple
socket strips.
▶
If the power cord is too short, contact Cus-
tomer Service.
▶
Only use adapters approved by the manu-
facturer.
ATTENTION!
Carrying the appliance by the door handle
could break it. The door handle cannot sup-
port the weight of the appliance.
▶
Do not carry or hold the appliance by the
door handle.
17.2 Appliance dimensions
You will find the dimensions of the appliance here
17.3 Installation below a worktop
Observe the installation dimensions and the installation
instructions when installing below a worktop.
¡
To ventilate the appliance, the intermediate floor
must have a ventilation cut-out.
¡
The worktop must be secured to the built-in unit.
¡
Observe any available installation instructions for the
hob.