CAN Keypad CK-M12
Getting started | en
5
Bosch Motorsport
Quick Start Manual
29.10.2019 | Version 1.1 |
2
Getting started
The following supplies are required to use the CK-M12:
–
CK-M12
–
Engine controller, data logger or related CAN enabled device
–
Appropriate harnessing to connect all devices,
note that the CK-M12 does not contain a
termination resistor.
These steps are recommended to get started with the CK-M12:
–
Verify the resistance across CANH and CANL is equal to 60 ohms with a multimeter when
the system is powered off. If 60 ohms is not found, check the CAN termination and refer
to the wiring diagram in section three.
–
Configure the CAN enabled device of choice to read the CAN messages from the CK-M12.
–
Provide power to the CK-M12 and verify CAN communications between the CK-M12 and
CAN enabled device.
–
Transmit indicator CAN messages for color and brightness to the CK-M12 and verify
response.
Summary of Contents for CK-M12
Page 1: ...CAN Keypad CK M12 Quick Start Manual Version 1 1 10 29 2018 ...
Page 2: ......
Page 24: ......