Graphic Keypads
Installer Reference Guide
4
Bosch Security Systems 03/16 Graphic Keypads BIRG FTR1.0
Installing The Keypad
The keypad should be installed onto a solid surface using suitable mounting fixtures. Make sure the screw heads
do not protrude above the surface of the mounting plate. Wiring should be performed while the control panel is
powered off.
Step 1)
Using the keypad mounting plate as a template, mark
out the location of the required mounting holes and
the cable entry hole before drilling out all points as
necessary. Mount the plate to the wall surface using
the bubble level as a guide.
Step 2)
Pass the wiring cable through the hole in the wall and
the mounting plate before terminating the wires on
the keypad terminals. Follow the provided connection
diagram and if applicable set the required keypad
address at this time.
Step 3)
If the keypad has a built in tamper switch, you will also need to install the
rear tamper screw in the rear tamper plate. Once installed use a knife to cut
the 3 small plastic tabs holding the rear tamper plate so it is no longer
connected to the keypad mounting plate.
Step 4)
To mount the keypad simply align the 4 rectangular
holes in the back of the keypad with the 4 hooks
on the mounting plate and then slide the keypad
down until it locks firmly into place.
Step 5)
To remove the keypad from the mounting plate,
place a small flat blade screwdriver at the bottom
of the keypad as shown and gently push the
screwdriver in toward the keypad until
the lock releases and the keypad slides
off the mounting plate.
Do not use the screwdriver to prize or
lever the keypad off the base plate or
damage will occur.
Figure 5: Removing Keypad From The Base Plate
Figure 6: Mounting Keypad To Base Plate
Figure 4: Rear Tamper Plate
Figure 3: Base Plate Mounting Options