DEPTH ADjUSTMENT
Disconnect plug from power source. Loosen
the depth adjustment lever located between
the guard and handle of saw. Hold the foot
down with one hand and raise or lower saw by
the handle. Align the bottom contour of depth
adjustment lever with the desired depth of cut
mark on calibrated depth bracket and tighten
lever. Check desired depth (Fig. 1).
Not more than one tooth length of the blade
should extend below the material to be cut, for
minimum splintering (Fig. 3).
90° CUTTING ANGLE CHECK
Disconnect plug from power source. Set foot to
maximum depth of cut setting. Loosen bevel
adjustment lever, set the bevel indicator to 0°
on quadrant, retighten lever and check for 90°
angle between the blade and bottom plane of
foot with a square.
Make adjustments by turning the small
alignment screw from bottom side of foot, if
necessary (Fig. 4).
BEVEL ADjUSTMENT
Disconnect plug from power source. The foot
can be adjusted up to 45° by loosening the
bevel adjustment lever at the front of the saw.
Align to desired angle on calibrated quadrant
and then tighten bevel adjustment lever (Fig. 5).
For bevel adjustments above 45° loosen bevel
adjustment lever, depress 45° stop spring (Fig.
6), align foot to desired angle mark over 45 ° on
quadrant and tighten lever.
Because of the increased
amount of blade engage-
ment in the work and decreased stability of
the foot, blade binding may occur. Keep the
saw steady and the foot firmly on the
workpiece.
Operating Instructions
LINE GUIDE
For a 0° cut, use the large notch in the foot.
For 45° bevel cuts, use the small notch (Fig.
6). The cutting guide notch will give an
approximate line of cut. Make sample cuts in
scrap lumber to verify actual line of cut. This
will be helpful because of the number of
different blade types and thicknesses
available. To ensure minimum splintering on
the good side of the material to be cut, face
the good side down.
53
25
20
15
1
0
BLADE
90°
FOOT
BEVEL
ADJUSTMENT
LEVER
QUADRANT
FIG. 4
BEVEL
INDICATOR
QUADRANT
BEVEL
ADJUSTMENT
LEVER
FIG. 5
FIG. 6
FOOT
45° BEVEL
CUTS
0° CUTS
PUSH 45° STOP
SPRING IN DIRECTION
OF ARROW FOR
BEVEL ADJUSTMENTS
ABOVE 45
°
45° STOP
SPRING
ALIGNMENT
SCREW
-10-
DEPTH ADJUSTMENT LEVER
ONE TOOTH LENGTH SHOULD PENETRATE
WOOD FOR MINIMUM SPLINTERING
FIG. 3
!
WARNING
BM 1619X08893 09-13_BM 1619X08893 09-13.qxp 8/29/13 9:04 AM Page 10
